Quote:
Originally Posted by Electronic M
Depending on the shaft metal and the file that is a 3-25 minute task.
You are seriously intimidated by not knowing how to use a metal file?....Seriously, would a screwdriver or saw intimidate you?....Cause a file is just as simple. I'm 24, there have always been tools laying around in my house, and I can't think of ONE that was too intimidating to just pick up and try to figure out and use on zero experience. And trust me files are not noisy.
You go to fleas, and presumably other second hand shopping.....I expect you could find a decent used file for 50 cents reasonably quickly if you keep your eyes open.
No money is a lousy excuse for letting a project overwhelm you....I've had times where I could not afford to buy caps, and needed to improvise with parts pulled from BPC TVs and dead CFLs, and had to sell at swap meets to get money to buy new sets, parts, and tools. Making gold out of dirt is an essential skill of restoration, and often that means stretching your dollar, material resources, tools and most of all your mind (to come up with better ways of doing so).
|
one of the flea markets I go to (which is where one of my customers that I repair some record players for him works and owns the shop) has a booth with nothing but tools in it and has hundreds of files in his booth for sale and I thought about buying a few files from him, but I wasn't sure what sizes I should get because I didn't want to get any files that were going to be too big or too small for what they would be used for. Plus I think he was a little overpriced, because he had a single file that was used and in kind of rough condition for $15...
11-22-2015, 04:15 PM
Threaded Mode