Yes, this is a tube deck.
Quote:
Originally Posted by Electronic M
Connect the heater secondary (lowest resistance)
|
If the lowest resistance is always for the heaters, then I know which winding my primary is. Of the two choices, I'm reasonably confident that the one with a 20 ohm resistance is my primary, especially since it's much close to the schematic resistance of 28 ohms than the 90 ohm winding.
If I'm understanding this correctly - I have two secondary windings. One has very little resistance and transmits a higher voltage to the heaters to warm the tubes. The other has a high resistance and drops the voltage significantly before it goes through the rectifier diode and grids.
Or am I completely off the mark on this?
12-25-2015, 10:50 PM
Threaded Mode