|
This is where the method of *Process Of Elimination* comes in handy. What i would suggest is to disconnect what is connected to pin 2 on V7 (6SQ7) & then power up the set & see if you still have hum. there should be silence. if the hum stops, You can eliminate the audio amp & output stage as being the problem. the problem then, would be somewhere upstream in the I.F. or in the audio detector stages. If the hum is still there, there is a problem with the source voltage from the B++ rail that supplies the audio amp stage.
Are you sure that the hum is a 60 cycle ripple, & not a buzz caused by sync pulses?
|
03-24-2018, 01:10 PM
Threaded Mode