Rca ctc-5h

[EdKozk2]

Originally Posted by Steve D.

Ed, Quite a creative solution. If I understand your posted photo below, I assume you cut off the heads of the bolts screwed into the rear of the mask. Or did you find double ended threaded screws? Nice job.

-Steve D.

In picture below, the top short bolt is the original hex head type I removed. I replaced with longer ones like below. I used die to increase the threads an extra inch or so. I could have used fully threaded new bolts also. I removed the entire plastic CRT mask to replace the bolts. They are seated in hex holes on the face of the mask. I use a little tape to keep them from falling out when re-installing the mask back in the cabinet.
I've done all the modification work with the cabinet laying face down on a quilt/ pad.
Ed