|
Well I think as far as trying to get this thing going completely goes, I'm just going to replace all of the open and out of tolerance resistors in each circuit one circuit at a time and test the TV out after each section is done to see what the TV is doing after each section is done, that way if I get the TV to give a raster and what not midway through then I'll know by what sections I just completed replacing the resistors in that those sections were what was responsible for the TV's issues and I'll know that more than likely the rest of the resistors that I hadn't touched yet by that point will more than likely be fine to leave in place (unless they are 5% or 10% tolerance resistors which then in that case I would just replace those because of the fact that those tighter tolerance resistors are a little more important to the circuit's functionality than the 20% tolerance resistor are).
|
10-31-2019, 01:13 AM
Threaded Mode