|
As Notimetolooz noted, it looks like the three strange resistors on the bottom are not resistors. They are either capacitors or inductors. If you still have the three parts you removed , you can check them with an ohm meter. If they were resistors as you thought, then you will get readings fairly close to the color codes. Where in the circuit did you remove them from ? Also make sure your Horizontal Drive Adjustment capacitor is not tightened all the way, it can cause the picture brightness to act up because your horizontal output will start to red plate as the set warms up. You can check for an arc at the base of your 1B3, the filament pins. See Post # 45's picture.
Ed
Last edited by EdKozk2; 04-30-2020 at 04:04 AM.
|
04-30-2020, 04:00 AM
Threaded Mode