Quote:
Originally Posted by MIPS
If I am remembering inductors correct, a resistance at or right next to 0 is fine.
I'd be verifying that it's not the transformer at fault as you know the wrong voltage is comping out of it, but you didn't say what was going in. I believe the tap numbering is listed in the service manual.
Also verify your entire bank of fuses are good with a continuity check. Sometimes when I get weird voltages on a feed circuit it's a cartridge fuse that's gone bad.
|
And here is the inductor in question. I can't even find any information online for how to determine the inductance of this coil, regarding the specific text on the side. Nothing I have found seems to match the type of text on the inductor. And there are no other markings anywhere on this inductor. It's very confusing to me.
05-20-2020, 01:32 PM
Threaded Mode