Zenith System 3 CRT help

[dieseljeep]

[QUOTE=rtsherrod81;3231220]Hello Zeno,

Thanks again for the information. I have pulled the HV board and found the cap you were referring to. It is a 4.7uF 315V and it has been replaced at least once before as can be seen from below. Someone got a little overzealous with the soldering iron and lifted the trace.

I noticed a label on the board that states "RE MFG IN MEX BY ZENITH" which could explain the repair. Therefore this is not the original HV board.

I need to place an order for another project and I will include this cap. Are there any others I should get as a just in case? Is the installed cap the correct value?

Regards,
Some of the soldering looks a little suspect!
BTW, I read a notice that came with a Zenith rebuilt 9-160 module that they wouldn't accept a module that had a trace blown off due to a lightning strike, as an exchange. It wouldn't meet standards as a U/L approved replacement part.
They never looked at them if they were packed in the box the replacement came in.
I never had one that was damaged that way!