|
I can't locate the instructions for building the following Mechanical TV receiver on Yancer's website under ETF. I think those original web pages were for the receiver only and not the camera. The disk was driven from the motor via a pulley assembly. The disks, pulleys and motors I purchased from Peter were for this kit.
I believe I copied those pages many many years ago but I can't locate on this PC. I will have to look on the hard drive of another PC that I have. Also those pages were from the "Experimental TV Society" newsletters written by Peter Yanczer which I have hard copies of but in storage again.
Last edited by rld-tv01; 07-31-2021 at 06:22 PM.
|
07-31-2021, 06:18 PM
Threaded Mode