|
|
|
#11
04-19-2026, 06:51 PM
|
||||
|
||||
|
I haven't removed the remote motor yet as I'm still trying to figure out if I remove it, will it go back in smoothly. It has a strange toothed base that seems to be misaligned as the teeth mesh perfectly on the top, but seem to be off on the bottom. I can also see the particles from the tan part all over as it sheds/scrapes off. There is also a set of teeth on the base of the motor shaft that turns another gear next to it and a leaf switch. I know I need to find out what is wrong as half the time when I change the channel, it either gets stuck and I have to go back and forth to make it move, or it moves but takes a second or two to finish the rotation.
I'm attaching a couple pics in case someone has seen this setup before and can give some insight on what might be going wrong.
__________________
Pioneer SX-1080, Pioneer PL-115D, Pioneer CT-F9191, Pioneer RG-1, Wollensak 8050A, Akai 4000DS MkII, Pioneer CS-05 & Polk 1.2TL Denon 5803A, Pioneer DVL-700, Pioneer CT-W603RS, Toshiba HD-A3, D-Link DSM-520, Dish VIP-722, Polk 1.2TL, CSi5, LS/fx, RT-800 and PSW-650 
|
|
|
Threaded Mode