|
""The set had a hum for sound with no evidence of picking up a signal.""
A 23" 1961 Zenith b/w console I have had that problem, turned out to have a few bad resistors in between the power supply and the IF sections. A 1971 19" b/w Zenith I don't have anymore also had that problem, it was just caused by a loose wire going to the filament on one of the IF tubes, causing it to not light up.
Those remotes show up on ebay alot, also they seem to be interchangeable, I use my SC600 remote on this set all the time. The buttons don't exactly correspond though, channel lower button changes the channel, and the channel higher is on/off-vol.
|
06-03-2007, 03:02 PM
Hybrid Mode
