Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Early B&W and Projection TV

Notices

We appreciate your help

in keeping this site going.
Reply
 
Thread Tools Display Modes
  #1  
Old 01-23-2009, 11:12 AM
Fredrik Fredrik is offline
VideoKarma Member
 
Join Date: Apr 2004
Location: Sweden
Posts: 17
Westinghouse H-251 focus problem

I have problems with the focus on my Westinghouse H-251 TV. Can not get the picture to focus properly, focus is best when the focus control is at maximum setting. Also the sound is weak and oscillates sometimes depending on the volume setting.
All paper capacitors and electrolytics are replaced and some bad tubes have been replaced also.
What can the problem be?
Attached Images
File Type: jpg tvbild1.jpg (33.1 KB, 53 views)
File Type: jpg tvbild2.jpg (115.4 KB, 43 views)
Reply With Quote
  #2  
Old 01-23-2009, 11:22 AM
bgadow's Avatar
bgadow bgadow is offline
VideoKarma Member
 
Join Date: Oct 2003
Location: Federalsburg, MD
Posts: 5,865
I would start by measuring the B+ to see if it is too low. It could be a weak LV rectifier. (5U4 or some such) I think this set is too old to use seleniums.
__________________
Bryan
Reply With Quote
  #3  
Old 01-23-2009, 11:32 AM
Fredrik Fredrik is offline
VideoKarma Member
 
Join Date: Apr 2004
Location: Sweden
Posts: 17
The B+ is OK. There are two 5U4G and they are tested and have very good emission.
Reply With Quote
  #4  
Old 01-23-2009, 01:15 PM
Eric H's Avatar
Eric H Eric H is offline
Administrator
 
Join Date: Jun 2002
Location: So. Calif
Posts: 11,565
You could have a bad resistor somewhere in the focus circuit.

It uses magnetic focus so as long as the coil is good it would probably have to be a voltage problem.

I would start at the focus control and check all the resistors in the circuit, chances are some of them have drifted up in value.

Do you have a schematic for it?
Reply With Quote
  #5  
Old 01-23-2009, 03:02 PM
Fredrik Fredrik is offline
VideoKarma Member
 
Join Date: Apr 2004
Location: Sweden
Posts: 17
I have checked the resistors there and they are OK. I have a schematic for it, but it is in poor quality and therefore difficult to read.
Reply With Quote
Audiokarma
  #6  
Old 01-24-2009, 10:01 PM
bgadow's Avatar
bgadow bgadow is offline
VideoKarma Member
 
Join Date: Oct 2003
Location: Federalsburg, MD
Posts: 5,865
Fredrik, I have a spare copy of what Sams published for this set. (they didn't offer a full packet, just schematics) I could mail it to you if you want. Send me a PM with your address if interested. Might take awhile to get to where you are, but I guess it took awhile for the Westinghouse to make it to!
__________________
Bryan
Reply With Quote
Reply


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 04:24 AM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.