|
|
|
|
|
#1
10-23-2009, 01:46 PM
|
|||
|
|||
|
seems the caps are fine, full voltage quickly, no heat, so I plugged in all the tubes and will hook up the crt/yoke/convergence bd tonight for a full power up. I will monitor the B+ current still.
will do this all later today, will post the results later. wish me luck... 
|
|
#2
10-23-2009, 03:04 PM
|
|||
|
|||
|
since I had the sams resistance tables I started check some, on the vert tube I had an odd reading on of the pins, noticed it was the vert hold, no big its just the position of the pot, move the pot and I get wild swings. check the pot and indeed it must be very dirty, so will clean up the pot before powering it up. I am just a bit paranoid about that vertical circuit
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
