|
|
|
|
|
#1
01-29-2010, 04:12 PM
|
||||
|
||||
|
Maybe the short is in the base of the tube. It could be worth your while to desolder the thing and confirm that. It's also worth checking out your crt checker and making sure there are no out of tolerance parts there. I had a tube checker that would occasionally give a "shorts" reading on a known good tube. I traced out the circuit, replaced a resistor, and now it is a lot less finicky.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
