CTC 5 in Ohio

[Steve D.]

Originally Posted by jeyurkon

Thanks for the advice. I might leave the finish alone. But, there doesn't appear to be fiberboard anywhere on this set. I've attached a photo of the damage on the top and to me it looks like birch plywood underneath the finish.

John

John,

I stand corrected on the Aldrich top being plywood under the photo finish. My Aldrich didn't have factory UHF, so I installed a UHF receiver inside the cabinet and drilled two holes in the side for the receiver knobs to protrude. I recall that at least the side panels were fiberboard or Masonite. This was many years ago. I don't drll holes in CTC-5's (or any vintage set) anymore. I do agree that you should leave the finish alone, although you probably could touch up the top a bit.

-Steve D.

[jeyurkon]

Originally Posted by Steve D.

John,

I stand corrected on the Aldrich top being plywood under the photo finish. My Aldrich didn't have factory UHF, so I installed a UHF receiver inside the cabinet and drilled two holes in the side for the receiver knobs to protrude. I recall that at least the side panels were fiberboard or Masonite. This was many years ago. I don't drll holes in CTC-5's (or any vintage set) anymore. I do agree that you should leave the finish alone, although you probably could touch up the top a bit.

-Steve D.

And you were right about the sides. They are Masonite.

John