|
|
|
|
|
#1
04-08-2010, 12:02 PM
|
|||
|
|||
|
I am going to leave them be, not sure about how those pins work that hold them in. I have a solder sucker iron that works great on PCB.
I hope to stuff the 3 section can tonight. I figure no hurry on replacing that NP cap since I just want to see if I can get it up and running thru the RF output anyway. 
|
|
#2
04-08-2010, 04:25 PM
|
|||
|
|||
|
Banderson, can you confirm the value of C9a/b. Per the schematic it is a 50/50mfd both at 150v.
It should be a can on the bottom of the set on the left side looking at it from the bottom, closest to the power tranny. Mine was switched out.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
