|
|
|
|
|
#1
05-21-2010, 12:09 PM
|
||||
|
||||
|
That set probably gets the B+ for the audio section off the flyback. It goes through a small diode, and a 1 ohm resistor used as a fuse. Then, there are some caps for filtering. It's not too bad if you have the schematic to follow.
I used to work on alot of Mitsubs when they were younger. Your set is a pain to move, but I never saw one with a bad kine. Your problem with caps was the typical problem. 
|
|
#2
05-28-2010, 06:09 PM
|
||||
|
||||
|
Model #? I have a huge database of symptom/cures fo Mitsubishi sets, and may be able to help. Does it have MTS audio? The MTS audio board was famous for problems on these....
Cheers,
__________________
Brian USN RET 22YRS (Avionics/Cal) CET-Consumer Repair and Avionics ('88) "Capacitor Cosmetologist since '79" When fuses go to work, they quit!
|
|
#3
05-28-2010, 06:31 PM
|
||||
|
||||
|
Cheers,
__________________
Brian USN RET 22YRS (Avionics/Cal) CET-Consumer Repair and Avionics ('88) "Capacitor Cosmetologist since '79" When fuses go to work, they quit! Last edited by Findm-Keepm; 09-29-2017 at 06:39 PM.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
