Fleetwood model 4068... Advice?

[VintagePC]

All right... Hope to have the set fully adjusted by tonight...

A simple comment,
alignment can be done on the bench with a signal generator, just jamming the needle
at either end of the range, and using the two frequencies specified (530 and 1620),
or in fact just the higher one since the coil is non-adjustable.

Dangit... Now I'll have to build a signal generator... (just kidding.)

I think your electrical
restoration is nearly complete. Congratulations, I look forward to the update in
your site. And I believe I already got all the credit due to me, which is not that
much, after all you did all the manipulations!

True, but it wouldn't have been possible without everyone's help! Next step is cabinet restoration and detail work... I've mentioned it before that I want to put some decent veneer over the hardboard crap, and strip/varnish the maple frame.

This thread possibly contains more
posts over its lifetime than all the rest of videokarma, and I believe this means something...

...and it shall be preserved in eternal glory when I'm done. (Going to mirror it on my site)