Runs great except............

[VA561]

This is the correct angle.

[jr_tech]

In the picture that I posted above, a screw head / 5/16" hex head (may be 1/4" on some models) screw tensions the metal clamp around the yoke. Reaching in from the back of the set, it should be in about the 11:00 position, near the left strut that comes from the front of the set, hidden by the flange of the focus coil...loosen it and you should be able to turn the yoke.
Loosen tension bolt on yoke clamp ... Pix 1
Reach around focus flange and turn yoke body... Pix 2

jr

[VA561]

Thanks everyone for the info. I was able to adjust the yoke and correct the picture tilt. Thanks Again