Finally...something like success

[jeyurkon]

Looking really good!

[Eric H]

Nice job!
Those DuMonts really have a great picture.

[ggregg]

AHHH...lost the raster. I had it almost completely buttoned up and I decided to watch it again. Had raster, no picture, had audio. Looked on the back and found the green wire disconnected from the neck connector and the bridge on the horizontal outputs had disconnected on one side (must have bumped it). I connected the wire and the bridge thing back up and had no raster. Disconnected the green wire and raster came back. Changed the connector with the one off the other DuMont, same pins and color code. Now no raster whether the wire is connected or not. I tested every tube associated with the horizontal section and they all tested good. HV seems fine from the spark I get when I discharge it. Picture tube heater is working. ??????????????????

[ggregg]

OK after a ton of checking, changing one cap, moving another (the original was apparently wrong according to schematic ??), a new horizontal output wire and finding a broken wire off a filter cap, I have it back. Maybe I can start my porthole pretty soon??

[DaveWM]

glad you found it, it does not take much to mess up a hand wired chassis.

I was checking a B+ for ripple, the set was on its side, the scope lead very lightly was hanging from the B+ and just bumped a disc cap that happened to have very thin leads. Well that pushed the cap lead against something it did not like. No smoke No damage and No pic, just the raster (it was an IF cap).

I was totally baffled how hookin up a scope lead to the B+ would cause a loss of signal. I just started looking very carefully to what I had just done and and tapped around that area, very very lightly. well the signal would pop back and then be lost, looking more I saw the cap right under the scope lead, eureka, I see it.

Moral of the story is when some works and then stops working , triple check all around where you were just before the loss. I have run into this several times, very old wires that break, parts move etc...

[ggregg]

You are correct sir. I watched it for over an hour, tweaking the picture again the whole time. It's just about there now.

Interesting thing is when I changed the filter cap, I taped the connection to avoid a short. The break was under the tape, which is why it took me so long to find it.