|
|
|
|
|
#1
09-13-2011, 09:25 AM
|
|||
|
|||
|
what was the original problem that pointed you to replacing the fly?
if you disconnect the plate cap from the horz out do you get 400vdc at the connector (the wire not the plate cap of the tube)? Last edited by DaveWM; 09-13-2011 at 09:34 AM. 
|
|
#2
09-13-2011, 10:25 AM
|
||||
|
||||
|
Check for a dead damper tube if there is no B+ on the plate cap of the horizontal output. A bad flyback could have killed it. If it's good, check for 390 volts on pin five of the damper.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
