high voltage loss

[timmy]

resistors from top to bottom of chassis, all electrolytics were changed , all that are listed.i did the grey scale setup and the g1 master if it is down low there is no picture because then ill put the bright up and its all bloomed and out of focus. well i better put the anode cap back on then. well im not giving up and its good no smoke coming from anywhere.i did not change any fixed caps but i clipped one leg on a few key ones to check with an ohm meter set on 20 meg nothing jumps out at all. and still the sams says after setting the hv to 24kv then it says to measure 1.2 volts dc across r155, i get nothing maybe because the hv has to be up at 24kv. i guess its motorola they were different.