GE roundie

[mstaton]

Yes, they don't work

[Electronic M]

Originally Posted by mstaton

Yes, they don't work

Same here...I was beginning to wonder.

PS:CTC17, have you been smoking the same stuff as that Sanjarali cat?...Misa no standingunder what yousa sayin'.

[DavGoodlin]

Originally Posted by Electronic M

Same here...I was beginning to wonder.

PS:CTC17, have you been smoking the same stuff as that Sanjarali cat?...Misa no standingunder what yousa sayin'.

Hey - at least no one here seems gislan.

[DaveWM]

went a ahead and tried it again, after jiggling the RF amp tube I was able to get a clear strong audio. I will prob give it a shot in a while with everything in, keeping an eye on the HOT cathode current of course.

[DaveWM]

good sound, HV comes up fine, HOT current about 185ma, horz just out of lock in range, can not flop the lines. Going to try some new tubes in a bit.

[DaveWM]

new 6BH11 got the horz to lock it, color working but a bit weak, contrast weak, and some odd horz shifting like a hum bar, but not a regular moving event.

I am going to try a new AGC tube and video out. The horz locks but can't flop both ways (lock at the end of the range). there are a few ceramic tube caps on the sweep board. The vert sync is not strong but it is there. Need to check the basics like the B+ etc... waiting on the service manual book for that.

[DaveWM]

well the ckt breaker popped so I guess I need to pull the chassis and check out the filters caps to see if they are shorting.

strike that not the breaker but a bad connection at the chassis interlock, but I do see a hum bar now so will check for HK shorts and if all good then will pull the chassis and check the filter caps.