Ctc-12

[Sandy G]

I used to smoke a cigar about 2-3X a year just to remind myself how badly I HATED them. Ever since my stroke, I absolutely cannot stand to be around cigarette smoke of any kind...Even going into a barn where tobacco is hung, curing, gets me.

[DaveWM]

test run with HOT and VOT pulled went well, B+ came up, filter caps seemed ok, tuner audio working. I don't have a yoke handy, if I did I was going to just hook it up and then meter the HV and see what happens. I will just install it in the set, just about as easy, maybe later tonight.

[DaveWM]

had a bit of fireworks by the service switch, seems like one of the terminals has a bit of a short to ground, maybe a carbon path, I was tempted to just let it burn out, but will replace it. may have one in my stash if not looks like something rat shack may have otherwise off to the surplus store again.

[DaveWM]

carbon track was on the outside, scraped it off and all good now. a quick neon bulb test of the plate caused it to light up, so looks like all is working well so far. will install in tv later.

[DaveWM]

looking good. color working sweep looks good, fly not getting hot. just a fast check. have dirty pot on color but so far so good. the Colorama CRT that did not test very well seem to be making a pretty good pic. will work on it some more and get some pics.

[DaveWM]

did a few house keeping chores on it today, 1st pulled all the tubes and sprayed on contact cleaner, and cleaned the contacts in the wafer switch type tuner. I am not a big fan of the wafer switch types as I find it harder to clean them, but I do like the way the fine tuning works, it has individual plastic screws that move around with the tuner, pushing on a single lever that fine tunes. I find this mech a bit hardier than the little gears and tuning slugs inside the channel coils on the turret types. Cleaned the pots in the front as well, they were a little bit touchy. I have been using a product called slick stuff for years, has a strong citric smell, seems to work very well (does not hurt carbon pots). its a cleaner and lubricant.

Last thing was I cut the 3a3 filament leads down. I had them full length from the new fly, which was about 3" too long, resulting in the lead coming up so high that they nearly touched the plate lead of the 3a3.

I noticed a tiny waft of smoke on startup from under the fly, my guess is its the big power resistor near the choke. the term strip looks fully baked (as they all do) and the wires show charred insulation right at the strip. I know I should replace the wire and sand the term strip so I can get a good connection, but for now I will leave it be.

Its all orig parts wise and I see no reason at this time to go changing anything. the only part change has been to cut out the AC line cap. did not replace it just cut it out so it would not explode on me.

[DaveWM]

decided to go a head and change out the .0082 cap in the feedback loop of the vert osc. this cap is always weak, and I did notice the vert was a bit lacking. While at it I will replace the .001 cap on the vert primary as well. Its a 2kv and I have no good way of testing it.