|
|
|
|
|
#1
03-18-2013, 04:00 PM
|
|||
|
|||
|
Hi All;
Timmy, Thanks for the warning.. My biggest problem with the Sams is since mine is a copy, and my eyesight isn't that great, I have trouble seeing those little details.. Like where wires go or are attached.. I have an 8TS30, that I use for comparison and the Ryders.. This set didn't have any compensation Cap on the 1st Video Amp, so I took it from the 830.. I am just about to try it for the second time today.. I have 6 (each) .047 Caps done as of now.. Its a little better each time I try it.. Still has smearing issues.. But I can make it lock and unlock , (I think) in both Vertical and Horizontal.. Its possible in the sync sections or still in the video sections.. I have some other Caps on order and they will not be here for a week or so.. THANK YOU Marty 
|
|
#2
03-18-2013, 04:35 PM
|
|||
|
|||
|
Hi All;
This is the longest that the set has been on !! I put a Video signal on the connector on the back, part of the Horiz. Sync Discrimiter.. I origionally thought it was part of the Sync Amp.. And I got some picture ..  Its a mess, but it is Video !!!I need most likely to replace the Sync Integrator Caps and Resistors, when they come in from Mouser.. I will look at the 1st and 2nd Sync Amps and the Sync Seperator and see If there is any other Caps that I have at the present that I can replace now.. THANK YOU Marty
|
|
#3
03-18-2013, 04:42 PM
|
|||
|
|||
|
By golly sounds like she's gettin' there.
 It might be s good idea, especially when replacing resistors, to power the set up after each replacement. If a resistor happened to be off value by a single decimal place, it can really throw you for a loop if you don't catch it right away.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
