Help Identify My New Zenith

[zeno]

Maybe I missed it but whats the chassis ## ?

IIRC the vert controls are on the module with little extention
shafts. If there is a large adjustment needed UNLESS the pot has
a bad spot or someone messed with it it HAS a problem.
You should do the vert next, it may cause more damage.
BTW your voltages are OK, its not unusual to tweek the
grey scale a little especialy an old set.
Be sure when doing your doing the final set-up the set has
run a few hours & is nice & warm.

73 Zeno

[TinCanAlley]

Originally Posted by zeno

Maybe I missed it but whats the chassis ## ?

IIRC the vert controls are on the module with little extention
shafts. If there is a large adjustment needed UNLESS the pot has
a bad spot or someone messed with it it HAS a problem.
You should do the vert next, it may cause more damage.
BTW your voltages are OK, its not unusual to tweek the
grey scale a little especialy an old set.
Be sure when doing your doing the final set-up the set has
run a few hours & is nice & warm.

73 Zeno

It's a 25EC58. The reason I want to adjust the sizing is I noticed that what I see on my 18 CC2 in the upper part of the screen is about 1" closer to the top or actually off the screen.

I got this set from someone that got it from a shop of sorts. It looks like they messed with things as I just noticed the deflection yoke clamp wasn't tightened down.