|
|
|
|
|
#1
08-12-2013, 09:06 PM
|
||||
|
||||
|
SUCCESS!!!!!!!!!!! I noticed that the red and black wires where connected to a thin metal circular plate. The plate had a slot on either side. I loosened the wing nut and took a small screw common screwdriver and gently tried to turn the plate clockwise from the back. It moved just enough to correct the tilt problem. I want to thank everyone who contributed advice. Thanks to you , this '55 Philco is running like a swiss watch!
|
|
#2
08-12-2013, 09:46 PM
|
||||
|
||||
|
Congratulations!
Since your Philco has a Tung-Sol CRT in it, probably someone has replaced the CRT. Even back these sets were relatively new (Philcos and older RCAs seemed to be worse), the old yoke would sometimes not fit correctly or something broke when one put a rebuilt CRT in. This could very well be the result of a repair done years ago. As long as you don't bump the yoke wires, this should be OK. James
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
