![]() |
|
|
|
#1
|
||||
|
||||
|
Those are great TV's. Before you do anything else, make sure the safety cap has been updated to the orange drop. If it still has the white cap (which, I doubt), it needs to be replaced before you turn it on again.
There's an electrolytic cap in the horizontal driver circuit that will cause picture pull-in and eventual shorting of the HOT. Back in the mid '90's, I bought one of these for fifty cents at a church rummage sale. The tripler was arcing and created quite an odor. After replacement, it was an excellent TV.
__________________
http://www.youtube.com/user/radiotvphononut |
|
#2
|
||||
|
||||
|
Its a 17" E-line or poss F. Abt '74 or '75 I think they had better pix than the
19", always liked them. For the width also check the 1.5 ohm resistor in the HOT base. For safety cap I dont see the label we put on them. It may have separate 22-5001 caps on the flyback & the bottom chassis. Change them all if it uses them. If it has one big one with 4 wires under the HOT heat sink change it if its white. Up to run 400 uses separate caps. Run 401 up uses one big cap. good luck 73 Zeno
|
![]() |
| Thread Tools | |
| Display Modes | |
|
|