Carbon composite in place of carbon film

[TinCanAlley]

Originally Posted by DaveWM

well those all look a bit high considering the G1 in the mid 30's give you a bias of about 160ish neg which is prob cutting of the CRT.
you would want it bias off more than normal since you want to reduce the beam current when the vert sweep is disabled but not completely cut off. Sorry I just know know what the exact number should be.



I would check the voltage of the output transistors next, and if you can get a good bright raster in reg but the serv mode does not work, then I would check the resistors and that ties the emitters of the outputs back to ground AND that blanking signal from the fly. Now would be a good time to trace the flyback signal with the scope.

It looks like the emitters get voltage from the emittier of the video driver in reg mode, but in the service mode they are grounded thru a 1.5k and a 12k that gets the flyback pulse. look this over carefully on the schematic until you see what I mean.

Okay, I got the voltages of each base of each output transistor (both in and out of setup).

The first value is SM, second is normal and the third is in setup mode.

Red: 15.6, 15.9 and 16.6
Green: 15.6, 16.1 and 16.7
Blue: 15.7, 16.2 and 16.8

I see on the schematic the setup/normal. In setup I see a 1.8K and a 18K (not the 1.5K and 12K you noted). After that, I see it tie in somewhere in the vert/horz blanking and then it goes to pin 4 of J201 and also is connected to green of T207. I'm lost after that. I can see how switching to setup takes the voltage away from the emitters fed by the video amps. T207 is the horizontal output transformer, so I guess that's the source of power for the emitters in setup. J201 pin 4 goes to the convergence board and I don't see how that fits in.

Guess I'm not getting that much better navigating schematics. If you could give me a clue as to where the flyback signal for probing is to be found, that would be great. I don't know where along the circuit to probe. Is it the H Sweep of the horizontal module, or the base of the horizontal output transistor? Or...is it in a completely different location?

Sorry to be such a pain. I hope I'm not coming along too slowly.