|
|
|
|
|
#1
09-16-2013, 10:28 AM
|
||||
|
||||
|
[QUOTE=TinCanAlley;3082296]I think you mean R240 and not R243. R243 is a 33ohm wire wound 3W located in another circuit.
QUOTE] I mean the resistor between H and M - the number is smudged, so if you say it's R240, that's the one. 
|
|
#2
09-16-2013, 10:51 AM
|
||||
|
||||
|
Okay, I'll go the route of cutting the resistor leads and such. Just out of curiosity, what wattage should the pots be? I had assumed they would need to be equal to or higher than the resistors in the current voltage divider circuit, but am not positive. The ones I got are for testing, so I didn't get quality ones. If/when I do it for use, I'll buy better pots.
__________________
Pioneer SX-1080, Pioneer PL-115D, Pioneer CT-F9191, Pioneer RG-1, Wollensak 8050A, Akai 4000DS MkII, Pioneer CS-05 & Polk 1.2TL Denon 5803A, Pioneer DVL-700, Pioneer CT-W603RS, Toshiba HD-A3, D-Link DSM-520, Dish VIP-722, Polk 1.2TL, CSi5, LS/fx, RT-800 and PSW-650
|
|
#3
09-16-2013, 10:53 AM
|
||||
|
||||
|
Okay, going to put this project on hold. The scope arrives today and I've got a bit of reading, setup and practice to do so I can fix the jail bar issue.
Thanks for all the input and being patient with me while I learn.
__________________
Pioneer SX-1080, Pioneer PL-115D, Pioneer CT-F9191, Pioneer RG-1, Wollensak 8050A, Akai 4000DS MkII, Pioneer CS-05 & Polk 1.2TL Denon 5803A, Pioneer DVL-700, Pioneer CT-W603RS, Toshiba HD-A3, D-Link DSM-520, Dish VIP-722, Polk 1.2TL, CSi5, LS/fx, RT-800 and PSW-650
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
