|
|
|
#1
12-15-2013, 09:42 AM
|
||||
|
||||
|
Red Flickers
I'm thinking either the CRT is getting a short, or the red bias POT is flakey.
I haven't adjusted it or taken it apart at all lately cause it's been working so well, but lately the red colors flickers a little, gets bright, normal, bright, normal, and it messes with the grayscale tracking too.. Where should I start? It seems completely intermittent, but only seems to do it once it's warmed up. 
|
|
#2
12-15-2013, 11:49 AM
|
||||
|
||||
|
Hi, my 1978 Sony had this issue upon warmup. It was simply poor solder connections on the video output board(crt neckboard). In fact, I've got a Zenith from about '81 which needed this done as well. Hopefully it isn't the picture tube itself.
|
|
#3
12-15-2013, 12:05 PM
|
||||
|
||||
|
Quote:
|
|
#4
12-15-2013, 02:12 PM
|
||||
|
||||
|
Bad PC cons on CRT socket board very common on a
lot of sets. If CRT is shorting usually goes very bright one color with retrace lines. A,little light tapping around can get it to act up & narrow things down. 73 Zeno 
|
|
#5
12-15-2013, 03:34 PM
|
||||
|
||||
|
My Zenith (see avatar) does the same thing once it is on for a few minutes. It will go away if I literally lift the back just a little (1/2 inch or so) and drop it on the table. Works fine after that. Could mine have a similar issue?
|
| Audiokarma |
|
#6
12-15-2013, 07:41 PM
|
||||
|
||||
|
Quote:
The control board up front ( color, tint etc) is a double sided PCB & the feed throughs went intermitant. Again light tapping around the chassis will usually smoke it out. Also when you get changes in color turn the color all the way down & see if the B&W picture is changing also. Narrows things down a lot. Remember a good color TV has to be a good B&W FIRST ! 73 Zeno
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
