|
|
|
|
|
#1
12-24-2013, 07:07 AM
|
||||
|
||||
|
Yes for 150V use anode of CR3205 as ground.
CR3473 on main board ( 9-214 ) ??? Left of main filter cap & a stand-up power resistor. Use cold ground for that. Fix zorched yoke wire now, if you are lucky its causing shut-down. 73 & merry Christmas Zeno 
|
|
#2
12-24-2013, 09:14 PM
|
||||
|
||||
|
I found CR3473. Clipped off that and metal corner mount of crt and got from 0 to 4 but realized i had left the ribbon cable off the main board that runs up to the crt board. when i put that back on, meter never went up at all. as for the blue yoke wire, i had to relocate that on up the trace to another location on the back side of the HV board as it had burned the board around that immediate area and the pin where the cable used to mount on had fell off. the smell i get now is just from the instance where i first turn the set on. it sparks there at the burnt area one second. what next?
|
|
#3
12-25-2013, 06:59 PM
|
||||
|
||||
|
Blue wire is low end of yoke. If you havent cut out all
the burned PCB & replace etch with wire. Also remove the burned connector & be sure the red wire is clean. Path of yoke is through LX3262 lin coil, LX3261 width coil, C3261 coupling cap, then TX3251 pin transformer. Also give the board a real good visual for bad PC cons etc. 73 Zeno
|
|
#4
12-25-2013, 07:19 PM
|
||||
|
||||
|
Ill let you know what happens. would this be why the 12v loss?
|
|
#6
12-26-2013, 12:22 PM
|
||||
|
||||
|
Well, last time i worked on this, i placed that blue wire on the back of LX3262. Why is it arcing out at the old location? It burned a hole big enough for maybe a pencil to go through. how do i correct this? Everthing else looks ok including the 2 K resistor.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
