|
Well I'm pretty much done going over the set , seems that the orange and brown drops are ok except for a couple I replaced , I didn't touch the if boad , I figure if theres a problem I will but left it alone , theres only one orange drop on it .
so as soon as I reconfirm that resistors I wasn't sure if they were ok or not I will give it a slow power up on the variac and then hope it works and will wonder how much adjusting may be needed as far as convergence.
what was the pin on the horizontal output tube I should measure the voltage on and what the voltage should be ? ( probably says it in the schematic )
mike
|
01-05-2014, 12:11 AM
Threaded Mode