Ground Loop "Hum" Using BT Modulator

[vts1134]

Originally Posted by N8NM

You might try disconnecting it where it enters the house and see if you get any improvement. Loose/bad cable connections can allow signals to leak, and these wouldn't have gone away when you cut power at your breaker panel.

It's kind of a long shot, but I've seen it before.

That was the first thing I tried. I run into this ground loop problem all the time at work, so is it was the first thing I thought of.

Originally Posted by zenith2134

Why are you attempting to broadcast on the lowest channel possible (channel 1)? AFAIK, the B.T.s cannot do broadcast at over the air 1...Even if they could, I would choose the highest channel allocation for the band..since any power-supply oscillations/anamolies would be furthest away from modulated signal space at a higher channel. I like 12 and 10 personally.
I do not care about other channel's digital transmit realm at all.......We are dealing with low power. it is an FCC "intentional RF radiator", true. But so is my garage door opener and my 802.11 N router...

Some of my sets only have three channel tuners so I have to use 1, 2, or 3.

[zenith2134]

Electronic M, do you have any factual evidence to confirm the statement regarding 'better DX ability' of lower frequency channels? It seems to me that the opposite would be true.

[ChrisW6ATV]

I did not see this specifically mentioned in this topic, so here is one thing that may have worked with this problem for me: Try plugging the modulator into one of those "grounding adapters" that have only two prongs, to eliminate the ground connection from the modulator to the building. Then, use a DVD player or VCR (also with its two-prong cord) as the signal source. (Do not have the VCR connected to any cable box or antenna system, just standing by itself.) Let me know if you tried this already.

[vts1134]

Originally Posted by ChrisW6ATV

I did not see this specifically mentioned in this topic, so here is one thing that may have worked with this problem for me: Try plugging the modulator into one of those "grounding adapters" that have only two prongs, to eliminate the ground connection from the modulator to the building. Then, use a DVD player or VCR (also with its two-prong cord) as the signal source. (Do not have the VCR connected to any cable box or antenna system, just standing by itself.) Let me know if you tried this already.

I tried this as well.