|
|
|
|
|
#1
09-03-2014, 12:50 PM
|
||||
|
||||
|
If you have yet to do so clean the tuner contacts. If your set has AGC adjusting it can help. Given the fine tuning issue your set may be out of proper alignment.
__________________
Tom C. Zenith: The quality stays in EVEN after the name falls off! What I want. --> http://www.videokarma.org/showpost.p...62&postcount=4 
|
|
#2
09-09-2014, 01:34 AM
|
||||
|
||||
|
I'll have to check and see if it's got AGC. I'm not too sure right now.
 Well, I adjusted the fine tuning some and got it set up pretty good. I just turned a few screw's like the schematic said, to "tune it up". These were the one's around the tuner and fine tuning knobs, so before anyone starts screamin' at me, I did not mess any with the alignment!...yet. It's still got the snow issue, but all sound has been fixed with the above chages. I also tested the tubes on that tuner and they are good! For some reason, the set is back to going to a dot when you shut it off. How do I eliminate this? I don't want an Ion burn in the future.  
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
