finally scored a flat chassis

[dieseljeep]

Originally Posted by zeno

Put normal-align switch in align ( not the service switch ).
Adj. APC control for least amount of color bars going through
picture. Go back to normal & see if its better. & dont forget
that 330 ohm, it can cause some subtle problems when
just starting to go.

73 Zeno

Is that the 330 ohm resistor on the 9-90 board?

[zeno]

Originally Posted by dieseljeep

Is that the 330 ohm resistor on the 9-90 board?

In the flat chassis 9-57 IIRC. Same resistor & function. IIRC
the only difference from 9-57 & 9-90 is the connectors are staggered on the
-57 & in a row on -90 but near identical otherwise.......
Hybrids, flats & uprights are much the same circuit wise.

73 Zeno