ctc12 clone beam current

[Electronic M]

I wonder if your HV reg tube socket is making proper contact with the tube pins? If not that would explain correct voltage at the socket, but incorrect behavior of the tube.

[timmy]

Originally Posted by Electronic M

I wonder if your HV reg tube socket is making proper contact with the tube pins? If not that would explain correct voltage at the socket, but incorrect behavior of the tube.

is it possible the wire burned inside the insulation ? if it did then i would pull the wire slightly and if it stretches then that could be it so ill look into that. the pins look very good and the tube fits tight in the socket, but i could check that again.