|
|
|
|
|
#2
07-13-2015, 11:17 AM
|
||||
|
||||
|
I have been in contact with a local powder coating place in Virginia Beach, and finally took the cabinet over there to have them look at it. Doing the whole cabinet comes to $150 out the door, but there's a catch. The blank off panel where the knobs of the chassis would normally be had a hole in it for a non-original HV meter, and it needs to be patched before proceeding. The welding shop I went to said its not possible to patch, due to metal warpage- you'd always know it was repaired. So they are making me a whole new one for like $50, when done it will get dropped off at the powder coating place. I should have the whole cabinet done next wee, the color will be satin (semi-gloss) black.
__________________
Evolution... 
|
|
#3
07-13-2015, 11:26 AM
|
||||
|
||||
|
Nick,
Anyway you can have the original graphics reproduced? Did you photograph or scan them when the panel was removed? -Steve D.
__________________
Please visit my CT-100, CTC-5, vintage color tv site: http://www.wtv-zone.com/Stevetek/ Last edited by Steve D.; 07-13-2015 at 11:31 AM.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
