|
agreed a lot of things can cause it, but before assuming there is a problem, try adjusting the vert hold just a bit, often you correct the interlace that way.
if that does not help you can look into the vert integrator. One of my toughest dogs was a set that had bad line pairing that I could not clear up. I ended up scoping around and found a strong horz pulse getting into the vert due to a leaky yoke. I new yoke cleared it right up. these kinds of problems are best sorted out with the help of a scope IMHO.
Last edited by DaveWM; 03-07-2015 at 05:02 AM.
|
03-07-2015, 04:58 AM
Hybrid Mode
