|
|
|
#11
06-05-2015, 06:08 AM
|
||||
|
||||
|
Two other ways to work on the chassis:
Everything on the chassis except the AGC, sweep, and HV will work without the yoke. You need to put a jumper in the yoke socket to connect the B+, though. You will need a bias box to set the AGC voltage. That will allow you to get almost all the circuits working before putting it back in the cabinet. Make a yoke extension cable and leave the yoke in the cabinet. 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode