|
|
|
|
|
#1
08-21-2015, 07:29 AM
|
||||
|
||||
|
checked both c912 and r912. both connected well. not sure how to test them. i'm assuming the board would need to be powered but not sure what meter setting to use. still trying to get used to this whole meter thing. the solder on r912 just has two different appearances. shiny and dull surface, im guessing made it look like it had lifted. any ideas?
rca2000, i have the pdf service manual if you want me to email it to you. Last edited by pac.attack76; 08-21-2015 at 07:36 AM. 
|
|
#2
08-28-2015, 04:07 PM
|
||||
|
||||
|
I guess i'll just order the chip and optcoupler. Chip is $16 shipped. How do i look up the optocoupler? I'm 3 days away from ordering so i just have to figure out what to do. If this doesnt fix the no power issue, then i dont know.
|
|
#3
09-01-2015, 05:24 PM
|
||||
|
||||
|
Well, off to the storage building she goes. Not sure what i need still so i didn't order anything. Probably sit in storage till i finally decide to toss it.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
