![]() |
|
|
|
#1
|
||||
|
||||
|
I swapped hundreds of 9-160's
IIRC -03 subs to -05 -04 subs to -06 there was also a -08 ( rare) that subbed back to one of them. An 05 or an 06 will sub ANY 9-160 between them. IIRC you can not put the wrong one in due to the yoke plug without forcing it & busting the skt. IIRC also the newer subs used a multivibrater to kick start the set & the old ones a transformer etc. On some, remotes IIRC there is also a cable that gets left off on a sub. Plugged on top & had 2 wires. Just tie it off out of the way. 73 Zeno
|
|
#2
|
|||
|
|||
|
9-160-05R Was the 25Kv HV Module.
9-160-06R Was the 30Kv HV Module. 9-160-08 or 09 were not available as rebuilt as far as I know. Does anyone have an older CRSP book I was thinking until the 08 and 09 came out it was odd suffix subbed odd suffix and even suffix subbed even. The one above: 9-160-05 = 9-160-04 9-160-06 = 9-160-04 Which most likely isn't correct ? Why would Zenith have made both the 05 and 06 as rebuilt replacements ? 9-160-05 would sub an 9-160-03 but not an 06. 9-160-06 would sub an 9-160-04 but not an 05. But the 08 and 09 mixed things up a bit. I think I still have the service seminar for the 9-160 series book somewhere. Then 2 weeks later the told us not to repair any of them exchange only. rrrhre2s Last edited by rrrhre2s; 09-26-2015 at 05:39 PM. |
|
#3
|
||||
|
||||
|
Quote:
Everyone with "I imagine, IIRC, and I seem to think" - Zenith says otherwise. I have no problems with what others do with their sets - just passing on the facts from Zenith. If someone has contradictory CRSPs, please post for the benefit of all. Edit: Somewhere I have the PTS Electronics cross reference as well - I'm gonna dig it up and scan that - they may have other info as well...
__________________
Brian USN RET 22YRS (Avionics/Cal) CET-Consumer Repair and Avionics ('88) "Capacitor Cosmetologist since '79" When fuses go to work, they quit! |
![]() |
| Thread Tools | |
| Display Modes | |
|
|