![]() |
|
|
|
#1
|
|||
|
|||
|
Quote:
|
|
#2
|
||||
|
||||
|
I have used a product called "goof off" successfully to remove latex paint splatters without damaging the underlying wood finish on older radios... I suspect that it would work ok on the KLH.
jt |
|
#3
|
|||
|
|||
|
Alright, I'll see about picking up a bottle of that. The only problem is that there's some paint spatters on one of the knobs as well and I tried scratching it off with my fingernail and it wouldn't come off and I know goof-off isn't going to be good to use on something like plastic because it has stuff in it that hard on plastic, so I wonder what I would use on the knobs to clean them up.
|
|
#4
|
|||
|
|||
|
Try the new Goof Off 2. "SAFE ON PLASTIC!"
|
|
#5
|
|||
|
|||
|
OK, I'll see if I can find some.
|
| Audiokarma |
|
#6
|
|||
|
|||
|
Well I replaced the original 2000 MFD 30V Power Supply Cap in the radio with a 2200MFD 50V capacitor and its still has a 60Hz Hum coming out of the speaker and still no audio out of the speaker from the tuner. So what should I check next in the circuit that could be causing my issue? I also tried posting this in AudioKarma but for some reason when I went to post it it wouldn't post it would act like it was going to post the thread but then it would wouldn't actually post anything.
|
|
#7
|
||||
|
||||
|
I would suspect that one or both of the diodes in the rectifier circuit could be shorted or have very high reverse leakage... you can get a manual here from Phil's old radio site:
http://antiqueradio.org/KLHModelTwentyOne21FMRadio.htm Thanks again to Phil Nelson for his wonderful site, jr |
![]() |
| Thread Tools | |
| Display Modes | |
|
|