![]() |
|
|
|
#1
|
|||
|
|||
|
I look forward to trying this tomorrow.
So the back comes off with the power off, one end of the multimeter goes to the pin (1 for red in this case) and the other end goes to the corresponding wire on the circuit board. Thank you. |
|
#2
|
||||
|
||||
|
Chances are pin 1 or 6 are open.
The cable usually breaks at a point where it is sharply bend or stressed. Usually at the 15 pin plug, or where it enters the monitor. Other failures are of course possible (red video amp stage somewhere inside the monitor), but broken cables are by far the most common problem here. |
![]() |
| Thread Tools | |
| Display Modes | |
|
|