Rca 621TS

[Crist Rigott]

Originally Posted by Electronic M

Hope you used high temp paint...If it is anything like a 630 chassis those power resistors get hot enough to solder with! The heat shrink is probably going to degrade after ~100 hours run time too.

Some places it is better to be practical than a perfectionist.

Rust-Oleum BBQ paint.

[Crist Rigott]

As I usually do, I ID each component with a little piece of masking tape according to the schematic/parts list. This helps me ID the parts and their location. Also alerts me to any irregularities that might be present. Here is a picture of the entire underneath followed by each quadrant.