|
|
|
|
|
#1
05-18-2017, 09:25 AM
|
||||
|
||||
|
Ok, thanks Tom. I'll try that!
|
|
#2
05-18-2017, 09:27 AM
|
||||
|
||||
|
I found that if I worked the horizontal lock coil in and out, at certain points the noise would stop. I still have little to no hv though. Thanks for the help guys!
|
|
#3
05-18-2017, 12:39 PM
|
|||
|
|||
|
Couple of questions. If you disconnect the plate connector from the HV rectifier, can you draw an 'air arc' from the connector (using a well-insulated screwdriver)? It should draw a nice quarter-inch to half-inch blue arc off the screwdriver. With the connector re-connected, can you draw the same arc?
Is the tube running hot? Last edited by old_coot88; 05-18-2017 at 12:42 PM.
|
|
#4
05-18-2017, 03:35 PM
|
||||
|
||||
|
I cannot draw an arc from the hv rectifier with it connected or not.
|
|
#5
05-18-2017, 05:00 PM
|
||||
|
||||
|
I replaced the 3900pf with a .0039uf film cap, but still no hv. I'm starting to run out of ideas on what is going on?
|
| Audiokarma |
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
