|
|
|
#6
06-11-2017, 09:32 AM
|
||||
|
||||
|
Make sure you have the store button released (out) before troubleshooting.
So many times I've seen these opened up for troubleshooting, only to see the operator had it in storage mode. Knobology strikes again.... Check for basic functionality first, then test the storage functions - they are inter-dependent and only when the analog basic (10MHz) scope is working should the storage features be tested. The Yahoo! TekScopes and TekScopes2 groups may be of help too.
__________________
Brian USN RET 22YRS (Avionics/Cal) CET-Consumer Repair and Avionics ('88) "Capacitor Cosmetologist since '79" When fuses go to work, they quit! 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode