CTC-4 Director 21

[SwizzyMan]

Originally Posted by Electronic M

You may need to adjust L86 (sams). It sets the relative phase angles of the demodulators...If it is off you will be able to get the red bar red and the blue bar blue but not both at once (and similar problems)... IIRC you have to adjust a slug on top of chassis and a slug under chassis simultaneously with plastic straight edge alignment screwdrivers (had to do this on my CTC-4).

If the color temp is right with the set operating in B&W mode then it is right, and does not need messing with....If turning on the color circuits throws the greyscale color temp off then there are problems in the color circuits causing that.

EDIT: BTW congrats on getting sync! It seems these sets like to get dirty intermittent tube sockets.

Glad it was just a matter of intermittent connection then that of a bad part! I'll give your suggestion a try.

[SwizzyMan]

Either im not adjusting L86 properly or we have a different problem here. After turning both shafts one turn CCW the screen develops a yellowish green tint. And after a turn clockwise it does the same thing. If i turn the slugs individually the top part of the coil seems to have a bigger effect than the bottom portion. What could I be doing wrong?