|
|
|
|
|
#1
06-28-2017, 07:09 PM
|
||||
|
||||
|
Check for filament voltage between pins 1 and 11 on the 11 pin adapter cable.
If present, suspect a problem in the metering circuit. If not present, look for a fault in the filament transformer, filament selector switch, life test switch, or filament set pot and associated 15K resistor. The "CRT Test" and "Beam Builder" lights are fed from a separate transformer than the CRT filament. 
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
