Sound Quality

[old_coot88]

If it's a 2-position switch, it's a simple treble-cut circuit using a single cap that's switched in or out (i.e., on/off). You can reduce the value of that cap till you find one that gives the tone you like best.

The cap usually goes to the plate of the output tube.

OOPs didn't see your last post. A .1 will definitely muffle it. A .01 or thereabouts would be more in the ball park.

[Tim R.]

Originally Posted by old_coot88

If it's a 2-position switch, it's a simple treble-cut circuit using a single cap that's switched in or out (i.e., on/off). You can reduce the value of that cap till you find one that gives the tone you like best.

The cap usually goes to the plate of the output tube.

OOPs didn't see your last post. A .1 will definitely muffle it. A .01 or thereabouts would be more in the ball park.

Yep, I think you're spot on about it being a treble cut switch. Although that wouldn't affect the low end, though, would it? It seems like the radio has excessive treble but lacks bass, so I wonder if there is something else "out of whack" in the preamp or final amp circuits?

I'll definitely swap capacitors around. And also verify that I put the correct value of cap in the tone switch when I restuffed it. Philco made things unnecessarily complex by leaving the part values off the schematics back then!


Thanks,

Tim

[old_coot88]

The treble-cut cap will affect the bass end very little.

You mentioned that the speaker had been reconed. Does the cone move in and out easily with no rubbing? If the new cone were too stiff, it could impair the bass.

If the coupling cap feeding the grid of the output tube were too low in value, it could reduce the bass without affecting treble. (A misplaced decimal point will change a value 10X.)

[Tim R.]

Originally Posted by old_coot88

The treble-cut cap will affect the bass end very little.

You mentioned that the speaker had been reconed. Does the cone move in and out easily with no rubbing? If the new cone were too stiff, it could impair the bass.

If the coupling cap feeding the grid of the output tube were too low in value, it could reduce the bass without affecting treble. (A misplaced decimal point will change a value 10X.)

Seems to be moving freely and properly, as far as I can tell. Is there a break-in period for speakers, like with a new car?

I'll check the coupling cap as well. That value was actually marked on the schematic (penciled in), but I'll double check to make sure the anonymous repairman wrote in the correct value.

Thanks,

Tim